J. For. Sci., 2006, 52(3):118-129 | DOI: 10.17221/4493-JFS

Effects of the thickness of rotary-cut veneers on properties of plywood sheets. Part 2. Physical and mechanical properties of plywood materials

J. Hrázský, P. Král
Faculty of Forestry and Wood Technology, Mendel University of Agriculture and Forestry Brno, Brno, Czech Republic

The second part of the paper summarizes results of an institutional research aimed at the determination of physical and mechanical properties of different sets of plywood sheets pressed under different conditions. The first part dealt with the determination of compressibility or values of decreasing the thickness of pressed plywood sheets. In this second part, results are summarized of the analysis of physical and mechanical properties of the set of whole-beech plywood sheets of the nominal thickness of veneers amounting to 1.5 mm. The plywood sheets were manufactured as seven-ply and urea-formaldehyde resin DUKOL S was used for their production. The sheets were pressed using a pressure of 1.5 and 1.7 MPa. Following parameters were analyzed: moisture, density, bending strength, MOE in bending and shear strength.

Keywords: plywood; MOE in bending; bending strength; shear strength; moisture; veneer; statistical analysis

Published: March 31, 2006  Show citation

ACS AIP APA ASA Harvard Chicago Chicago Notes IEEE ISO690 MLA NLM Turabian Vancouver
Hrázský J, Král P. Effects of the thickness of rotary-cut veneers on properties of plywood sheets. Part 2. Physical and mechanical properties of plywood materials. J. For. Sci. 2006;52(3):118-129. doi: 10.17221/4493-JFS.
Share...
Download citation
  • BibTeX (.bib)
  • Bookends (.ris)
  • EasyBib (.ris)
  • EndNote (.enw)
  • EndNote 8 (.xml)
  • ISI WoS (.isi)
  • Medlars (.medlars)
  • Mendeley (.ris)
  • MODS (.xml)
  • Papers (.ris)
  • RefWorks (.txt)
  • RefManager (.ris)
  • RIS (.ris)
  • MS Word (.xml)
  • Zotero (.ris)
    • Open full article

    References

    1. MATOVIČ A., 1993. Fyzikální a mechanické vlastnosti dřeva a materiálů na bázi dřeva. Brno, MZLU: 212.
    2. POLÁČIK A., 1979. Technológia výroby konštrukčných veľkoplošných materiálov. Časť 1. Výroba dýh a preglejovaných dosák. Zvolen, VŠLD: 232
    3. POŽGAJ A. et al., 1993. Struktura a vlastnosti dreva. Bratislava, Príroda: 486.
    4. ŠTELLER Š., 1967. Príspevok k stanoveniu niektorých pevnostných vlastností preglejok výpočtom. Bratislava, ŠDVÚ, Drevársky výskum, 1: 29-38.
    5. ŠTELLER Š., 1978. Vplyv vlhkosti na pevnosť v ohybe a modul pružnosti v ohybe celobukových vodovzdorných preglejok. Bratislava, ŠDVÚ, Drevársky výskum, 4: 255-266.

    This is an open access article distributed under the terms of the Creative Commons Attribution-NonCommercial 4.0 International (CC BY NC 4.0), which permits non-comercial use, distribution, and reproduction in any medium, provided the original publication is properly cited. No use, distribution or reproduction is permitted which does not comply with these terms.


    Return to the content